Knowledge and advice
Outdoor digital signage: choosing, placing and permits
Everything about outdoor digital signage: from brightness and IP rating to permits and local bylaws. Practical guide for installers in the Netherlands and Belgium.

Outdoor digital signage: choosing, placing and permits
Outdoor digital signage are weather-resistant digital screens placed outdoors for advertising, information or navigation. They differ from indoor screens by higher brightness (minimum 2.500 nits), a robust housing (IP54 or higher) and temperature resistance. In the Netherlands and Belgium, specific permit requirements apply for installation, and these can vary greatly by municipality.
In short
- Outdoor displays need at least 2.500 nits for readability in direct sunlight; for south-facing locations, allow for 5.000 nits or more.
- An IP rating of IP54 protects against dust and splash water; for full outdoor use, IP65 or higher is recommended.
- For most outdoor installations you need a planning permit or APV exemption — apply for this early, as lead times can extend to 8 weeks.
- Municipalities such as Amsterdam and Rotterdam have their own advertising policies with restrictions on size, light output and animation speed.
- Pixio Display supplies outdoor displays including advice on location requirements and permit procedures.
What makes an outdoor display different from an indoor screen?
A standard office screen reaches 300 to 500 nits. Outside, in direct sunlight, that is unreadable. Outdoor displays start at 2.500 nits and go up to 10.000 nits for the most challenging locations. In addition to brightness, temperature management plays a major role: a display in a glass showcase can heat up internally to 60 °C in summer sun if there is no active cooling.
The housing must comply with the IP standard (Ingress Protection). IP54 means protection against dust and splashing water; IP65 is completely dust-tight and resistant to water jets. For displays directly exposed to rain — think of a freestanding pillar in a car park — IP65 is the minimum. Some manufacturers supply IP67-certified screens that survive short immersion. Read more in the article IP ratings explained: from IP54 to IP67.
How many nits do you need?
The required brightness depends on three factors: orientation (north/south/east/west), direct or indirect sun exposure and viewing distance. As a rule of thumb:
| Situation | Recommended brightness |
|---|---|
| Covered, no direct sun | 1.500 – 2.500 nits |
| Partially shaded | 2.500 – 4.000 nits |
| Facing south, direct sunlight | 4.000 – 7.000 nits |
| Fully open location, high contrast required | 7.000 – 10.000 nits |
Manufacturer Samsung states in its outdoor display guides that readability in direct sunlight is only guaranteed above 3.500 nits (source: Samsung Display Solutions whitepaper, available via samsung.com/business). Pixio Display, a supplier of digital signage in the Netherlands and Belgium, always recommends taking an on-site measurement with a lux meter before selecting a screen if in doubt. More details can be found in the article Brightness (nits) outdoors: how much do you need?
Weather resistance: heat, cold and rain
Dutch winters bring temperatures down to -10 °C; in summer, a metal housing can internally reach up to 70 °C without ventilation. Choose a display with a certified operating temperature range of at least -20 °C to +60 °C. Some models have a built-in heating element for cold start in frost.
Vandal resistance is a second point to consider. For publicly accessible locations — bus stops, shopping streets, event sites — toughened glass (IK08 or IK10) is strongly recommended. IK10 means resistant to an impact of 20 joules, comparable to a punch. Read more in the article Weather-resistant displays: what do you need to know about heat, cold and rain?
Concrete example: At the Jaarbeurs in Utrecht, temporary outdoor displays are used during trade fairs. The venue is covered but draughty and damp. Here IP54 with IK08 is sufficient, while brightness may be limited to 3.000 nits because of the shade cast by the roof.
Permits: when do you need what?
This is the part that most often surprises installers. In the Netherlands, outdoor advertising installations fall under two regimes:
- Environmental permit (activity: building or advertising) — required when the display is permanently fixed to a building or forms a standalone structure. Application via the Omgevingsloket (omgevingsloket.nl). Lead time: 8 weeks under the regular procedure, up to 26 weeks under the extended procedure.
- APV exemption (General Local By-law) — required for temporary or mobile displays on the public road or in public space. Each municipality has its own APV; the conditions vary widely.
Since the Environment and Planning Act came into force (1 January 2024), permit procedures in the Netherlands have been consolidated via the Environment Desk. In Belgium, the application goes through the Environment Desk of the municipality or province concerned, depending on the scale of the project.
Read the full overview in the articles When do you need a permit for an outdoor display? and What is a permit and do you need one for signage?
Municipal advertising policy: comparing the major cities
Local councils may establish their own advertising policy within the framework of the Environmental and Planning Act. This leads to large differences:
- Amsterdam has a strict aesthetic policy in the city centre. Animated or flashing advertising is prohibited in protected cityscapes. Maximum light output is set at 300 cd/m² at night in residential areas (source: Municipality of Amsterdam, Advertising and Display Regulations 2022).
- Rotterdam allows more in harbour areas and along motorways, but applies a maximum screen size of 4 m² in the city centre for unlicensed locations.
- The Hague and Utrecht working with a whitelist of permitted advertising locations; outside that list, a bespoke application is required.
In Belgium, in addition to the municipal APV, regional regulations also apply (Flanders: VCRO; Wallonia: CoDT). Read the comparative article Advertising rules in Amsterdam, Rotterdam, The Hague and Utrecht: the differences for a full overview.
Concrete example: A retail chain wanted to place five outdoor displays along the Coolsingel in Rotterdam in 2023. Two locations fell outside the approved list. After a bespoke application with a planning advisory opinion, three displays were eventually permitted — with the condition that animations could contain at most one movement per 10 seconds.
Advertising tax: what do you pay per municipality?
Many Dutch municipalities levy advertising tax on public advertising. The rate varies by municipality and by type of display. Amsterdam, for example, charges per m² of advertising surface per year; Rotterdam charges a fixed amount per object. Some municipalities exempt small or temporary displays.
For installers, it is important to include this in the project budget in advance. A display of 2 m² in Amsterdam can cost current price on request in advertising tax per year (source: Tax and Customs Administration municipal levies, to be consulted via vng.nl). Read the full overview in the article Advertising tax by municipality: overview of the largest cities.
Practical checklist for installers
Before placing an outdoor display, go through these steps:
- Location analysis — measure the lux values at the time of maximum sun exposure.
- Screen choice — determine required nits, IP rating and IK rating based on location and duration of use.
- Permit check — check whether planning permission and/or an APV exemption is required via omgevingsloket.nl.
- Advertising tax — ask the municipality whether, and how much, advertising tax applies.
- Power connection — outdoor displays consume 150 to 600 W; provide a grounded outdoor connection with residual current protection.
- Fixing and foundation — check the load-bearing capacity of the floor or façade; have a structural calculation made for displays above 15 kg.
- Content management — ensure a stable network connection (4G or wired) for remote content updates.
- Maintenance — schedule a cleaning and inspection at least twice a year.
Concrete example: For the placement of an outdoor totem pole at a petrol station along the A2 near Utrecht, a planning permit was required (building + advertising), an APV exemption from the municipality of De Ronde Venen and a notification to Rijkswaterstaat because of its proximity to the motorway. The full process took 14 weeks.
Comparison: freestanding pillar vs facade-mounted
The two most common placement types each have their own advantages and disadvantages:
| Feature | Freestanding column (totem) | Facade mounting |
|---|---|---|
| Viewing angle | 360° possible | Limited to one direction |
| Permit | Always planning permission | Depending on municipality and size |
| Foundation | Concrete base required | Not applicable |
| Wind load | Higher requirements (NEN 8700) | Lower risk |
| Installation costs | current price on request | current price on request |
| Vandalism risk | Higher | Lower |
For busy shopping streets with one-way foot traffic, façade mounting is often the quicker and cheaper choice. In car parks, at petrol stations or on exhibition grounds, a freestanding column offers more flexibility in positioning.
Conclusion
Outdoor digital signage is a field that combines technical knowledge, site knowledge and legal knowledge. The right brightness, IP rating and enclosure are the basis; the permit strategy determines whether a project is delivered on time and within budget. Start the permit application early, carry out a site measurement and involve the local authority at an early stage. Pixio Display supplies outdoor displays — from compact wall-mounted screens to large freestanding pillars — and advises installers in the Netherlands and Belgium on the complete project chain.
Read more about outdoor and permits
- Advertising tax by municipality: overview of major cities
- Planning permission for signage: when do you need one?
- Weather-resistant displays: surviving heat, cold and rain
- Municipal by-laws and outdoor digital signage: what does the council regulate?
- Advertising rules in Amsterdam, Rotterdam, The Hague and Utrecht compared
- Outdoor display in winter: frost, condensation and heating
Frequently asked questions
What is the minimum number of nits an outdoor display needs?
For a shaded outdoor location, 2.500 nits is sufficient. In direct south-facing sunlight you need at least 4.000 to 7.000 nits. Manufacturers such as Samsung state that readability in direct sunlight is only guaranteed above 3.500 nits.
Which IP rating do I need for an outdoor display?
IP54 is the absolute minimum for a sheltered outdoor location. For displays directly exposed to rain, choose IP65 or higher. IP67 also provides protection against short immersion and is suitable for the most extreme conditions.
Do I always need a permit for an outdoor display?
Not always, but in most cases yes. A permanently mounted display on a façade or as a standalone structure requires a planning permit. For temporary displays on the public highway, an APV exemption is often required. Check this via omgevingsloket.nl.
How long does a permit procedure for an outdoor display take?
The standard procedure via the Omgevingsloket takes 8 weeks. With an extended procedure — for example in protected cityscapes — this can increase to 26 weeks. For complex locations, always allow for at least 3 months' lead time.
What is the difference between a planning permission and an APV exemption?
An environmental permit is required for permanent structures and is applied for via the Environmental Counter. An APV exemption regulates use of public space and is applied for at the municipality. Sometimes you need both for the same project.
May I place an animated display in the city centre?
This depends on the municipality. Amsterdam bans animated advertising in protected cityscapes. Rotterdam allows animations outside the central shopping area. Always check the local advertising policy before using moving content.
What does advertising tax cost for an outdoor display?
The amount varies by municipality. In Amsterdam you pay per m² of advertising space per year; a display of 2 m² can cost €400 to €800 per year. Some municipalities exempt temporary or small displays. Consult vng.nl for an overview by municipality.
Which is better: a freestanding totem or façade mounting?
A freestanding kiosk offers more viewing angles and flexibility in positioning, but requires a foundation and always an environmental permit. Wall mounting is cheaper and quicker to install, but limits visibility to one direction. Choose based on location and target audience.
What power consumption should I budget for an outdoor display?
Outdoor displays consume between 150 and 600 watts, depending on size and brightness. Provide a earthed outdoor connection with residual-current protection. For larger installations or multiple screens, a calculation by an electrical installer is required.
Do different rules apply in Belgium than in the Netherlands for outdoor signage?
Yes. In Belgium, the permit application goes through the municipal or provincial Omgevingsloket. Flanders works with the VCRO (Flemish Code of Spatial Planning), Wallonia with the CoDT. Pixio Display has a branch in Paal-Beringen and also advises Belgian installers on local regulations.